SEEDHAWK®TOOLBAROPERATOR’SMANUAL49
6.0 SBR®
HITCH
TOOLBAR
ONLY,
LOUP
III
&
SCT
6.1 REQUIREMENTS
1.FieldmustbeseededwithG.P.S.autosteerandsamerowspacingtheyearbefore.
2.Mustseedinexactlythesamedirectionasthepreviousyear.
3.Thesensingarmmustfollowbetweenthetworowsofstubble4”‐6”abovetheground.
6.2 OPERATION
NOTE:BEFORE OPERATION OF THE SBR, MAKE SURE THE TOOLBAR IS FOLDED DOWN IN
WORKINGPOSITION.
1.LowertheSBRarmintofieldworkingpositionbyremovinglockingpinshowninFIGURE28.
TheSBRmustbeinthedownpositiontofunctionproperly.
2.Adjust paddle height by using the adjustment bolt at the top of the SBR arm shown in
FIGURE28,sopaddlewillrunbetweenthestubblerows.
3.Infield operationturnthe SBR switch to ON/AUTO.REFER TO SECTION 4.5,pertainingto
thecontrolsystembeingused.
4.When SBR is not in use, turn the SBR switch to CENTERING.On SCT switch boxes OFF is
centering.On LOUP III monitor switch boxes use the CENTERING switch to center the SBR
hitch,turnswitchtoOFF.REFERTOSECTION4.5,pertainingtothecontrolsystembeingused.
5.Lift the SBR arm into lock position and
insertlockingpin,FIGURE28.
Lockpinlocation
SBRad
ustmentbolt
FIGURE28
Commentaires sur ces manuels