Seed-hawk Ground Drive 2010 Calibration Guide Manuel d'utilisateur télécharger pdf (Page 7)

Seed Hawk

Manual Calibration Guide 6

As stated on the screen: set the

gearbox on the implement to a

setting of 100 using the

increase/decrease switch on the side

mounted control box and PRIME

THE METER to ensure full flow at the

beginning of the calibration.

Note: Empty the product out of the calibration bucket, this is

not needed for the rest of the calibration procedure.

Once this step is complete,

highlight the “Start Box” using

the Selector Knob and use

the Enter Key or Toggle

Button to select Start.

Step 2:

The screen now displays the number of meter

revolutions counted with “Continue” highlighted. Turn the meter a

number of revolutions while catching the metered material in the

catch bin. Stop turning the meter. The number of revolutions is

displayed. Press Continue to save the information collected

during the calibration procedure.

NOTE: There is no set number of cranks required. It's

recommended to take as large of sample as possible.

1 2 3 4 5 6 7 8 9 10 11 12 ... 34 35

Pas de commentaire

Seed-hawk Ground Drive 2010 Calibration Guide Manuel d'utilisateur Page 7