Seed-hawk Ground Drive 2010 Calibration Guide Manuel d'utilisateur télécharger pdf (Page 8)

Seed Hawk

Manual Calibration Guide 7

Step 3:

The screen now displays the number of revolutions

counted during the calibration. “Weight 10.00lbs” is highlighted.

Press the Toggle Button or Enter Key to enter the actual

measured value of the material weight in the catch bin. Press the

Toggle Button or Enter Key to accept the value.

NOTE: As this value is entered other values on the screen

will change as the monitor calculates the correct gearbox

setting to achieve the desired application rate for the

implement width and material density entered.

Step 4:

Close to the bottom of this window display is “Set

Gearbox to” and then the number. Set the gearbox to that setting

using the increase/decrease switch on the side mounted control

box.

Step 5:

Highlight the OK Option using the Selector Knob. Press

the Enter Key or Toggle Button to finish the calibration of this

meter.

Step 6:

Repeat steps 1-5 for each additional meter.

Note:

It is recommended to repeat calibrations to avoid operator

error.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 34 35

Pas de commentaire

Seed-hawk Ground Drive 2010 Calibration Guide Manuel d'utilisateur Page 8